Making that QSO on 50Mhz largely depends on being there at the right moment.
However, some rigs offer that tiny bit of extra performance which is sometimes needed to hear the other guy at all.
I always enjoyed the ergonomics and user interface of the TS-570SG. This medium sized rig is a joy to use and easy to carry during holidays. I use it already for two years now as my main 50Mhz rig.
In order to enhance its performance I opted for two modifications:
- Exchange the std 2400Hz SSB filter for an Inrad 2100Hz
- Add a temperature controlled crystal heater from Kühne Electronics (DB6NT)
Installing the SSB filter
The original Kenwood 2400 Hz (YK88S) is taken out and exchanged for the Inrad 2100Hz (#94).
The '2100' offers better sound quality thanks to a near optimal filter shape. Its bandwitdh is a perfect balance between the std. wide 2K4 and the thin sounding 1K8.
The TS-570 does have one optional filter slot, but that is already taken by a 400Hz Inrad CW filter.
The filter is installed upside down, using insulating material and hot glue.Two customized pieces of RG316 are been used to connect it to the pcb.
Installing the crystal heater
At http://www.kuhne-electronic.de/en/shop/155_Crystal_Heater
you will find all info on this 13 euro (only) product.
Just slide it on the crystal of your main LO and apply hot air to let the heath shrink tube do its job.
How does it perform?
I was able to make a qso with this S7 YU-station on 6m while another SV-station S9+20 was at only 1.5Khz above. Subjectively this is surely different from the past. But since I cannot do an A/B comparison this means ZILT. It only proves that the SV station had a clean signal.
Epilogue
I have been very active on 6m these last two weeks since Es propagation has just started.
I managed to work: I, 4X, SV, ON PA,UR,LZ, LX, DL,EA,CT,YO,LZ,YU, HA, OM, SP,4L, ES,OH,YL,EA8,ER,CU,IS,9H,EI,EA6
Inter-continental: KP4
Am I happy?
No, not entirely.
The TS570 still does not sound optimal. I know it suffers from some phase noise and this is shown by the fact that I have a hard time hearing the other station. It is buried in noise and garbage. The other stations are worked on first or second call with 100W. A soon as I can hear them I can work them easily. But on many occasions I cannot read their reply or report. Very frustrating. Changing settings on the rig does not help. Using the calibrated SSB Electronics masthead preamp doesn't help either.
Picked up an IC-746 with Inrad filters from a friend who does not use it. I have had such a rig in the past too; they are very very nice to operate at 50Mhz and 144. Within minutes during a hectic Es bandopening I'm on a roll; this is just wat is needed.
The Icom is in a different league. Both on reception quality and ergonomics it does for me what it takes on 6m; quick and versatile operating options. RX is better, now I can hear into the noise layers and hear dx at sub-consious level.
Wkd: V4, 8P9, TA, EA9, T9 (again 2 new countries :)
No comments:
Post a Comment